CutForge™ trimmer replacement head made of steel wire

The lawn grows faster than you can cut it – and your trimmer is stuck again.

Thick overgrowth, stubborn weeds, and tangled lawn edges regularly stop normal trimmer lines. The CutForge™ steel wire trimmer head turns your existing trimmer into a much more aggressive cutting tool. The reinforced, twisted steel wire design cuts through dense grass, moss, and rough ground cover with fewer clogs and interruptions – so you can cover more area in less time.

Benefits

• No more getting stuck in the middle of cutting: The sturdy steel wire lines don’t stop where normal nylon lines give up – dense weeds, tough grass, and stubborn edge growth are cut continuously without you having to stop and rewind all the time.
• Less time in the garden, more results: Because the head causes fewer interruptions and cuts more aggressively, the area is finished sooner – saving you multiple adjustments and extra passes over overgrown spots.
• No doubt whether the tool will make it again: Designed for repeated use on demanding outdoor areas – the steel wire design maintains its cutting performance over many uses, so you don’t have to check after every mowing if the head is still holding up.

Specifications

• Material: Reinforced, twisted steel wire
• Variants: 3 cutting heads or 6 cutting heads
• Compatibility: Replacement head for common trimmer systems
• Application areas: Outdoor areas, lawn edges, paths, overgrown spots

Usage

1. Prepare: Turn off the trimmer and remove the old head according to the manufacturer’s instructions.
2. Mount: Attach the CutForge™ head onto the drive shaft and secure it until it clicks into place.
3. Use: Start the trimmer and move it evenly over overgrown areas, edges, and paths – the steel wire lines will do the rest.

Pro tip: For especially dense spots, guide the CutForge™ head in slightly overlapping swings – this prevents individual blades from slipping under the head and results in a more even finish.